Overview
Manuals
Principle
Revisions
Features:
- PACSystems TM RX3i
- 8-Channel, Isolated, Resistance Temperature Detector (RTD) Input module
- The module must be located in an RX3i Universal Backplane
The IC695ALG508 input module is an isolated RTD input module designed by GE Fanuc Automation. This module is specifically designed for use with the RX3i PACSystems mid-range controller. The primary goal of the RTD input module is to enable direct connection to two-wire and three-wire RTD temperature sensors without the need for external signal processing equipment (such as transmitters and sensors).
All RTD signal processing is handled by the module itself. The GE Fanuc Automation IC695ALG508 isolated RTD input module provides eight isolated RTD input channels. Each channel can be individually configured to suit different RTD or resistor applications.
The IC695ALG508 GENERAL ELECTRIC (RTD) Input module may still be available for purchase and support from Moore Automated Company beyond End-Of-Life (EOL) by the manufacturer (OEM).
GENERAL ELECTRIC IC695ALG508 (RTD) Input module datasheet(manual), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
The GE Fanuc Automation IC695ALG508 isolated RTD input module is currently active, is a resistor-type module, and provides inter-channel isolation. The module uses a general-purpose backplane and PCI bus for backplane support, occupying one rack slot. The GE Fanuc Automation IC695ALG508 isolated RTD input module provides comprehensive fault diagnosis for open and short circuits, and features positive/negative rate of change and high/low alarm functions.
Revision Part #
Also known as
IC695ALG508CA
IC695ALG508-CA, Series CA, Rev CA
IC695ALG508DB
IC695ALG508-DB, Series DB, Rev DB
IC695ALG508EB
IC695ALG508-EB, Series EB, Rev EB
IC695ALG508FB
IC695ALG508-FB, Series FB, Rev FB
