Overview
Length Code
Manuals
Armor Routing
System Match
Features:
- The 16710 base number identifies the armored interconnect-cable family documented for the 177230 Seismic Transmitter.
- Suffix -12 defines a 12 ft ordered length, approximately 3.6 m, within the official 3 to 99 ft.
- Replacement selection must retain armored construction, the complete length code and the verified transmitter-to-monitor connection interfaces.
Bently Nevada 16710-12 is the 12 ft armored interconnect-cable execution listed for the 177230 Seismic Transmitter system. The full part number combines the 16710 armored family with the -12 length suffix, so correct selection depends on the installed route, both termination interfaces and connected hardware rather than appearance alone. Preserve cable support, bend protection and grounding continuity during replacement.
Manufacturer reference: Baker Hughes/Bently Nevada 177230 Seismic Transmitter Datasheet 177232, 16710-AA armored cable ordering table. Moore Automated supports exact-item verification and spare-part enquiries for 16710-12 .
The 16710-12 may still be available for purchase and support from Moore Automated Company beyond End-Of-Life (EOL) by the manufacturer (OEM).
Understanding the -12 code
The complete cable number identifies both construction and ordered route length.
- 16710 specifies the armored interconnect-cable family.
- The -12 suffix records a 12 ft length, approximately 3.6 m.
- Other suffixes represent different lengths and should not be treated as identical replacements.
16710-12 documentation and reference links.
Important Notice: Confirm the complete catalog identity, hardware revision, receiving-system configuration and required document revision before replacement.
Routing the armored cable
Install 16710-12 only on a route that fits the documented 12 ft length and protects the armored assembly.
- Support the cable so neither connector carries the route load.
- Avoid sharp bends, crushing and contact with unsuitable hot or moving surfaces.
- Preserve shielding and grounding continuity before checking the transmitter signal.
Connected-system verification
Compatibility is established from the complete installation, not cable appearance alone.
- Confirm the connected 177230 Seismic Transmitter identification.
- Verify the monitor-side input and both mating interfaces before disconnection.
- Record the original route, grounding and support arrangement for reinstatement.
