Overview
Manuals
Compatibility Review
Field Installation Notes
Configuration Breakdown
Features:
- 20015x accelerometers: 200150-02-CN belongs to the documented manufacturer product family.
- Configuration: mounting option 02 using a 3/8-24 to 3/8-24 UNF hex-plate stud, CN approval, 100 mV/g sensitivity, and 10 Hz to 1 kHz frequency range.
- Verification: Confirm the 200150-02-CN marking, mounting stud, CN approval, cable, and monitoring input before replacement.
Bently Nevada 200150-02-CN is general-purpose accelerometer with 3/8-24 hex-plate mounting stud designed for Trendmaster 2000 and Trendmaster Pro acceleration-to-velocity monitoring channels. According to the official manufacturer documentation, it measures machine-case acceleration and supplies a differential voltage signal for general machinery monitoring. The ordering identity records mounting option 02 using a 3/8-24 to 3/8-24 UNF hex-plate stud, CN approval, 100 mV/g sensitivity, and 10 Hz to 1 kHz frequency range, so the complete suffix and nameplate information should be reviewed for a maintenance replacement, system extension, or critical spare.
Technical details for 200150-02-CN are limited to the applicable Baker Hughes Bently Nevada datasheet and official ordering information. Final suitability depends on the Trendmaster/ProTIM channel, 25 m maximum cable length, mounting surface, connector, and approval.
The Bently Nevada 200150-02-CN general-purpose accelerometer with 3/8-24 hex-plate mounting stud is supported by Moore Automated for verified industrial replacement and spare-part requirements.
Bently Nevada 200150-02-CN general-purpose accelerometer with 3/8-24 hex-plate mounting stud manual(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Compatibility Review
Confirm the Trendmaster/ProTIM channel, 25 m maximum cable length, mounting surface, connector, and approval. Compare the complete 200150-02-CN ordering code and nameplate data with the installed item before purchase.
Field Installation Notes
Follow the manufacturer instructions and verify stud engagement, mounting torque, sensor orientation, cable connector, shield routing, and channel setup. Any cable, connector, housing, mounting hardware, or matched transducer component is separate unless listed in the quotation.
Configuration Breakdown
mounting option 02 using a 3/8-24 to 3/8-24 UNF hex-plate stud, CN approval, 100 mV/g sensitivity, and 10 Hz to 1 kHz frequency range. Use the official ordering table to confirm every suffix, country approval, and custom MOD detail that applies.
