Overview
Manuals
Integration Requirements
Commissioning Guidance
Model Selection
Features:
- 20015x accelerometers: 200155-00-CN belongs to the documented manufacturer product family.
- Configuration: 200155 low-frequency sensor, mounting option 00 with no stud, CN country approval, 100 mV/g sensitivity, and 2 Hz to 10 kHz frequency range.
- Verification: Confirm the 200155-00-CN marking, mounting-stud requirement, CN approval, cable, and supported ProTIM channel before replacement.
Bently Nevada 200155-00-CN is low-frequency case-mounted accelerometer without a supplied mounting stud designed for Trendmaster low-frequency acceleration-to-velocity monitoring channels. According to the official manufacturer documentation, it converts machine-case acceleration into a differential voltage signal for slow-rotating machinery monitoring. The ordering identity records 200155 low-frequency sensor, mounting option 00 with no stud, CN country approval, 100 mV/g sensitivity, and 2 Hz to 10 kHz frequency range, so the complete suffix and nameplate information should be reviewed for a maintenance replacement, system extension, or critical spare.
Technical details for 200155-00-CN are limited to the applicable Baker Hughes Bently Nevada datasheet and official ordering information. Final suitability depends on a low-frequency Acceleration-to-Velocity ProTIM/DSM/System 1 channel, maximum 15.24 m cable, mounting surface, and approval.
The Bently Nevada 200155-00-CN low-frequency case-mounted accelerometer without a supplied mounting stud is supported by Moore Automated for verified industrial replacement and spare-part requirements.
Bently Nevada 200155-00-CN low-frequency case-mounted accelerometer without a supplied mounting stud manual(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Integration Requirements
Confirm a low-frequency Acceleration-to-Velocity ProTIM/DSM/System 1 channel, maximum 15.24 m cable, mounting surface, and approval. Compare the complete 200155-00-CN ordering code and nameplate data with the installed item before purchase.
Commissioning Guidance
Follow the manufacturer instructions and verify bearing-housing location, 3/8-24 mount selection, torque, cable connector, and channel configuration. Any cable, connector, housing, mounting hardware, or matched transducer component is separate unless listed in the quotation.
Model Selection Notes
200155 low-frequency sensor, mounting option 00 with no stud, CN country approval, 100 mV/g sensitivity, and 2 Hz to 10 kHz frequency range. Use the official ordering table to confirm every suffix, country approval, and custom MOD detail that applies.
