Overview
Manuals
Integration Requirements
Commissioning Guidance
Model Selection
Features:
- 20015x accelerometers: 200155-02-CN belongs to the documented manufacturer product family.
- Configuration: mounting option 02 using a 3/8-24 to 3/8-24 UNF hex-plate stud, CN approval, 100 mV/g sensitivity, and 2 Hz to 10 kHz response.
- Verification: Confirm the 200155-02-CN marking, mounting stud, approval, cable length, and low-frequency channel type before replacement.
Bently Nevada 200155-02-CN is low-frequency accelerometer with 3/8-24 hex-plate mounting stud designed for Trendmaster low-frequency acceleration-to-velocity monitoring channels. According to the official manufacturer documentation, it measures low-frequency machine-case acceleration for slow-rotating equipment monitoring. The ordering identity records mounting option 02 using a 3/8-24 to 3/8-24 UNF hex-plate stud, CN approval, 100 mV/g sensitivity, and 2 Hz to 10 kHz response, so the complete suffix and nameplate information should be reviewed for a maintenance replacement, system extension, or critical spare.
Technical details for 200155-02-CN are limited to the applicable Baker Hughes Bently Nevada datasheet and official ordering information. Final suitability depends on the mounting surface, low-frequency ProTIM/DSM/System 1 channel, maximum 15.24 m cable, and CN approval.
The Bently Nevada 200155-02-CN low-frequency accelerometer with 3/8-24 hex-plate mounting stud is supported by Moore Automated for verified industrial replacement and spare-part requirements.
Bently Nevada 200155-02-CN low-frequency accelerometer with 3/8-24 hex-plate mounting stud manual(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Integration Requirements
Confirm the mounting surface, low-frequency ProTIM/DSM/System 1 channel, maximum 15.24 m cable, and CN approval. Compare the complete 200155-02-CN ordering code and nameplate data with the installed item before purchase.
Commissioning Guidance
Follow the manufacturer instructions and verify stud engagement, mounting torque, sensor orientation, connector sealing, and cable routing. Any cable, connector, housing, mounting hardware, or matched transducer component is separate unless listed in the quotation.
Model Selection Notes
mounting option 02 using a 3/8-24 to 3/8-24 UNF hex-plate stud, CN approval, 100 mV/g sensitivity, and 2 Hz to 10 kHz response. Use the official ordering table to confirm every suffix, country approval, and custom MOD detail that applies.
