Overview
Manuals
Principle
Technical
Performance
Features:
- Proximity Probe Housing Assemblies
- 31000 and 32000 Proximity Probe Housing Assemblies
- The 31000/32000 Proximity Probe Housing Assembly is made of polyphenylene sulfide (PPS)
When proximity probes need to be mounted inside a machine housing, the 31000/32000 type proximity probe housing assembly is recommended. This assembly is typically used for radially mounted sensors, whether for vibration or key phase measurements. Using a proximity probe housing allows for easy external access to the proximity probe and its extension cables, enabling gap adjustment or probe replacement without disassembling the machine.
The 31000/32000 type proximity probe housing assembly is made of polyphenylene sulfide (PPS), an advanced high-strength thermoplastic material with excellent corrosion resistance. Other components of the housing assembly are made of corrosion-resistant stainless steel. Versions of this housing assembly pre-installed with the 3300 XL type proximity probe and various conduit fittings are available by order.
The 31000-31-05-20-058-00-02 Bently Nevada Proximity Probe Housing Assemblies may still be available for purchase and support from Moore Automated Company beyond End-Of-Life (EOL) by the manufacturer (OEM).
Bently Nevada 31000-31-05-20-058-00-02 Proximity Probe Housing Assemblies Manuals(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
The 31000/32000 type proximity probe housing assembly fully complies with the American Petroleum Institute (API) 670 standard requirements for externally mounted proximity probe housings. When installed with an approved sensor system and appropriate I.S. barriers, the 31000/32000 proximity probe housing assembly can be used for intrinsically safe hazardous area applications.
1. Environmental Protection: The plastic housing meets NEMA 4X and IP66 certification standards, preventing water spray from the hose.
2. Housing Weight: The typical weight of this assembly is approximately 1.2 kg (2.6 lbs).
3. Sealing Materials: Internal seals include a fluororubber O-ring between the probe tip and the housing, and a neoprene O-ring between the sleeve and the housing.
4. Standards Compliance: This assembly fully complies with the housing requirements of the American Petroleum Institute (API) 670 standard.
This system provides high-precision measurement of static and dynamic displacement for monitoring shaft position and vibration.
Linear measurement range: 2 mm (80 mils).
Output sensitivity: 7.87 V/mm (200 mV/mil).
Gap voltage: Typical values are between -9 V and -11 V DC when the gap is correct and centered within the linear measurement range.
