Overview
Manuals
Terminals
Compatibility
Wiring Checks
Features:
- Exact Siemens order number 6ES7392-1AM00-0AA0.
- 40-Pole Front Connector for the documented S7-300 system.
- Replacement requires saved wiring and hardware configuration.
6ES7392-1AM00-0AA0 is a SIMATIC S7-300 front connector with 40 screw terminals for field wiring on compatible signal modules. It accepts 0.14 to 0.75 mm² conductors (AWG 24 to 19), with one wire per terminal or two conductors up to 0.75 mm² in a shared end sleeve. Before replacement, record the complete label, installed slot, wiring, accessories and retained hardware configuration; after installation, verify diagnostics and every affected channel or controller function.
Before removal, create the required backup and label all connections. After installation, restore only the approved configuration and complete the documented electrical, communication and functional checks.
The Siemens 6ES7392-1AM00-0AA0 40-Pole Front Connector is listed as Obsolete / Discontinued by OEM. Current revision, availability and supplied scope are confirmed in the written quotation.
Siemens 6ES7392-1AM00-0AA0 Official Product Manual, Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
It accepts 0.14 to 0.75 mm² conductors (AWG 24 to 19), with one wire per terminal or two conductors up to 0.75 mm² in a shared end sleeve.
Use only the ratings and settings documented for the complete 6ES7392-1AM00-0AA0 order number. Record the installed values before replacement and compare every configured channel or interface after commissioning.
6ES7392-1AM00-0AA0 belongs to the Siemens S7-300 platform. Match the rack or station, front connector, adjacent modules, bus architecture and saved hardware configuration; a visually similar Siemens part is not automatically interchangeable.
Before removal, isolate energy, save the project or channel parameters and identify every conductor and connector. After installation, check supply, diagnostics, communication and all affected functions under a controlled commissioning procedure.
