Overview
Manuals
Manipulator Cable
Heavy-Arm Fit
Overhaul Service
Features:
- 3HAC024385-001 uses the documented the harness is listed for the IRB 6600 / IRB 6650 configuration and is not a universal cable for every ABB robot specification and requires confirmation against the supplied item and installed ABB configuration.
- 3HAC024385-001 performs the documented it provides axes 1-6 manipulator wiring, with connector and routing details retained as part of the replacement identity function within the approved ABB equipment configuration.
- 3HAC024385-001 uses the documented complete article number, robot label, connector layout and cable clearance must be checked before installation specification and requires confirmation against the supplied item and installed ABB configuration.
ABB identifies 3HAC024385-001 as a axes 1-6 manipulator cable harness used in the IRB 6600 / IRB 6650 robot configuration. Its documented role is axes 1-6 manipulator wiring, with the complete harness carrying the full manipulator cable routing and connector arrangement. The spare is a cable assembly rather than a controller or electronic module; compatibility is governed by the robot variant, connector positions, clamp locations, cable routing and any recorded harness revision. The applicable ABB spare-parts documentation should be read together with the installed unit marking before a replacement is selected. Mechanical similarity alone is not evidence of interchangeability.
ABB manufacturer documentation identifies 3HAC024385-001 as an axes 1-6 manipulator cable harness for use within the documented product-family configuration. Review the official family documentation together with the complete product label to confirm the article number, interfaces, compatibility, revision and installation limits before replacement or commissioning.
The 3HAC024385-001 ABB Axes 1-6 manipulator cable harness is listed as Active / Available from OEM. Current revision, availability and supplied scope are confirmed in the written quotation.
ABB 3HAC024385-001 IRB 6600/6650 Manipulator Harness Manuals/Datasheets/Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
The assembly provides the full axes 1–6 manipulator wiring for the documented IRB 6600 / IRB 6650 family. Selection depends on the complete robot configuration, not cable appearance alone.
Confirm the long harness path, connector transitions and clamp points on the articulated arm. Check bend radius and clearance throughout the operating envelope before energizing.
Photograph the installed routing and identification marks, isolate the robot, install the like-for-like assembly and complete a controlled motion and signal check after service.
