Overview
Manuals
Construction Details
Ordering Configuration
Installation Guidance
Features:
- 24701 Stainless Steel Probe Housing
- 303 Stainless Steel Body and 304 Stainless Steel Sleeve
- No Probe or Probe Cable Supplied
- 1.5 in Standoff and 3.7 in Probe Penetration
- 3/4-14 NPT Plug and Mounting Thread
The Bently Nevada 24701-00-00-15-037-04-02 is an all-metal proximity probe housing assembly for externally mounting a reverse-mount probe on rotating machinery. Its stainless steel construction provides a durable mechanical interface between the machine case, probe sleeve, conduit connection and protective dome cover.
The ordering code identifies a housing without a probe or cable, a 1.5-inch standoff adapter, a 3.7-inch penetration length, one 3/4-14 NPT plug and a 3/4-14 NPT mounting thread. Probe selection, sleeve support, target clearance and hazardous-area requirements must be verified from Baker Hughes document 141600 before installation.
The 24701-00-00-15-037-04-02 Bently Nevada proximity probe housing may be supplied and supported by Moore Automated according to the stated OEM lifecycle and confirmed stock condition.
Bently Nevada 24701-00-00-15-037-04-02 Proximity Probe Housing Assembly Manuals(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Housing Construction:
- 303 stainless steel housing body
- 304 stainless steel probe sleeve
- Threaded dome cover and conduit port
- O-rings and thread seal for the assembly
The 24701 design uses stainless steel for both the main housing and probe sleeve. The official typical mass is 1.8 kg without fittings. The selected fitting and mounting options must be installed with suitable sealing practices for the machine environment.
Ordering Code Breakdown:
- 24701: Stainless steel probe housing assembly
- 00: Probe not required
- 00: Probe cable not required
- 15: 1.5 in standoff adapter
- 037: 3.7 in probe penetration
- 04: One 3/4-14 NPT plug only
- 02: 3/4-14 NPT mounting thread
Use the complete order number when checking compatibility or requesting a replacement. Changing any code position can alter the probe, cable, standoff, penetration, fitting or mounting interface.
Installation Guidance:
- Confirm the 3/4-14 NPT machine-case interface
- Verify the 38 mm standoff and 94 mm penetration dimensions
- Check probe side-view and rear-view clearance
- Add sleeve support when the official length limit requires it
- Use the selected probe system manual for gap and wiring procedures
This configuration is supplied without a probe, cable or conduit fitting. Select the reverse-mount probe and cable separately, then verify system length, approvals, environmental limits and conduit sealing before commissioning.
