Overview
Manuals
Temperature Option
ETR System Match
Hot-Service Setup
Features:
- The documented thread size is M10 × 1; confirm the installed mounting interface, available reach and mechanical clearance before replacement.
- The documented unthreaded length is 0 mm; confirm the installed mounting interface, available reach and mechanical clearance before replacement.
- The documented case length is 30 mm; retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
330103-00-03-10-02-02 is a Bently Nevada 3300 XL 8 mm metric proximity probe for the 3300 system. It measures shaft vibration or position without contact in a matched transducer chain. Key specifications: Thread Size: M10 × 1; Unthreaded Length: 0 mm. Match the full order code and hardware before replacement.
330103-00-03-10-02-02 is a non-armored, standard-temperature 3300 XL 8 mm metric probe with M10 × 1 mounting thread, 30 mm case, 1.0 m integral 75 Ω FEP-insulated triaxial cable, and a miniature ClickLoc coaxial connector without protector; use it with a 330180-10-00 1.0 m Proximitor Sensor, observe the 25.4 mm minimum cable bend radius and 15 mm maximum thread engagement, and gap the AISI 4140 target at approximately 1.27 mm (-9 Vdc) for radial vibration service.
The exact 330103-00-03-10-02-02 execution must be confirmed by its complete order code, condition, connected 3300 system and included scope before purchase or replacement.
Bently Nevada 330103-00-03-10-02-02 3300 XL 8 mm metric proximity probe manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Preserve every option block of 330103-00-03-10-02-02. Retained facts: Thread Size: M10 × 1; Unthreaded Length: 0 mm; Case Length: 30 mm. Mechanical length, thread, cable/connector and approval suffixes are part of the exact probe identity.
Match probe family, electrical length, extension cable and Proximitor Sensor. Confirm target material, available travel, nearby probe spacing and mounting geometry before exchange.
Set the operating gap from live bias voltage, support the cable above its bend limit and verify runout, vibration or position response against the commissioning baseline.
