Overview
Manuals
Principle
Application Details
Features:
- 3300 XL 8 mm Proximity Probes
- 3300 XL 8 mm Proximity Transducer System
- 330103 3300 XL 8 mm Probe, M10 x 1 thread, without armor
The system provides an output voltage that is directly proportional to the distance between the probe tip and the observed conductive surface and can measure both static (position) and dynamic (vibration) values. The system’s primary applications are vibration and position measurements on fluid-film bearing machines, as well as Keyphasor reference and speed measurements.
Each 3300 XL 8 mm Transducer System component is backward compatible and interchangeable4 with other nonXL 3300 series 5 mm and 8 mm transducer system components. This compatibility includes the 3300 5 mm probe, for applications in which an 8 mm probe is too large for the available mounting space.
The 330103-00-22-50-12-RU Bently Nevada 3300 XL 8 mm Proximity Probes may still be available for purchase and support from Moore Automated Company beyond End-Of-Life (EOL) by the manufacturer (OEM).
Bently Nevada 330103-00-22-50-12-RU 3300 XL 8 mm Proximity Probes Manuals(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
The 3300 XL 8 mm system delivers the most advanced performance in our eddy current proximity transducer systems. The standard 3300 XL 8 mm 5-meter system also fully complies with the American Petroleum Institute’s (API) 670 Standard for mechanical configuration, linear range, accuracy, and temperature stability. All 3300 XL 8 mm proximity transducer systems provide this level of performance and support complete interchangeability of probes, extension cables, and Proximitor sensors, eliminating the need to match or bench calibrate individual components.
Reciprocating compressors (piston rod drop): A 2.2-inch (22) housing length allows the probe to penetrate thicker compressor septa or intermediate septa, enabling monitoring of piston rod position and wear.
Large steam and gas turbines: Used for axial (thrust) position or key phase signals. Reverse mounting allows technicians to precisely adjust the probe gap from the outside while the turbine is running at low speeds.
Hydropower generators: Used to monitor shaft vibration or centerline. Typically, a 5.0-meter (50) conductor is required to reach the perimeter of the turbine pit without the use of an intermediate extension cord.
Eurasian oil and gas/power plants: The RU suffix indicates compliance with EAC/GOST standards, a mandatory requirement for legal installation in the R
