Overview
Manuals
Temperature Option
ETR System Match
Hot-Service Setup
Features:
- The documented value for probe and approvals is 3300 XL 8 mm probe without approvals; the complete approval suffix must match the installation area and site requirements.
- The documented value for standoff adapter is No standoff adapter; retain this specification when matching the exact proxpac xl proximity transducer assembly and installed Bently Nevada 3300 hardware.
- The documented value for probe penetration is 3.9 in (99.06 mm); retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
330880-16-00-039-03-02 is a Bently Nevada PROXPAC XL Proximity Transducer Assembly for the 3300 system. It measures shaft vibration or position without contact in a matched transducer chain. Key specifications: Probe and Approvals: 3300 XL 8 mm probe without approvals; Standoff Adapter: No standoff adapter. Match the full order code and hardware before replacement.
Confirm the complete 330880-16-00-039-03-02 order code, installed signal chain, mounting arrangement and commissioning record before replacement.
The exact 330880-16-00-039-03-02 execution must be confirmed by its complete order code, condition, connected 3300 system and included scope before purchase or replacement.
Bently Nevada 330880-16-00-039-03-02 PROXPAC XL Proximity Transducer Assembly manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Preserve every option block of 330880-16-00-039-03-02. Retained facts: Probe and Approvals: 3300 XL 8 mm probe without approvals; Standoff Adapter: No standoff adapter; Probe Penetration: 3.9 in (99.06 mm). Mechanical length, thread, cable/connector and approval suffixes are part of the exact probe identity.
Match probe family, electrical length, extension cable and Proximitor Sensor. Confirm target material, available travel, nearby probe spacing and mounting geometry before exchange.
Set the operating gap from live bias voltage, support the cable above its bend limit and verify runout, vibration or position response against the commissioning baseline.
