Overview
Manuals
Technical Specifications
Configuration Notes
Application Guidance
Features:
- 3300 XL NSv Proximity Transducer System
- M8 × 1 thread, without armor
- 110 mm case and 1.0 m total probe length
- Protected standard ClickLoc cable
Bently Nevada 330903-00-11-10-01-CN is a 3300 XL NSv proximity probe configured for non-contact vibration, position, speed and Keyphasor measurements where restricted mounting space or small targets make an NSv sensor appropriate.
The complete code specifies an M8 × 1 probe without armor, zero unthreaded length, a 110 mm case, a 1.0 m total length and a protected standard ClickLoc connection. The NSv system provides a nominal 7.87 V/mm scale factor and a 1.5 mm linear measuring range when used with its matching extension cable and Proximitor sensor.
The 330903-00-11-10-01-CN Bently Nevada proximity probe is available through Moore Automated with configuration verification and support for compatible 3300 XL NSv components.
Bently Nevada 330903-00-11-10-01-CN 3300 NSv Proximity Probe Manuals(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Technical Specifications
- Probe thread: M8 × 1
- Unthreaded length: 0 mm
- Overall case length: 110 mm
- Total probe length: 1.0 m
- Nominal scale factor: 7.87 V/mm
- Linear range: 1.5 mm
- Probe tip material: PPS
- Operating temperature: −52 °C to +177 °C
These values describe the complete 330903-00-11-10-01-CN ordering configuration. System performance requires the matching NSv extension cable, Proximitor sensor and approved target material.
Configuration Notes
The first ordering fields identify the 330903 M8 × 1 unarmored NSv probe family, followed by 0 mm unthreaded length and a 110 mm case. The 10 field specifies a 1.0 m total probe length, while 01 specifies the protected standard ClickLoc cable option.
The CN suffix identifies a country-specific configuration. Confirm local approval, matching NSv system length, connector type and mounting clearance before substituting another probe code.
Application Guidance
Use the probe for non-contact radial vibration, axial position, tachometer, zero-speed or Keyphasor measurements in compact machinery installations. Maintain correct sideview clearance, set the mechanical gap using the manufacturer’s system curve and route the cable away from sharp bends and electrical interference.
Do not mix the NSv probe with an unmatched extension cable or Proximitor sensor. Verify the entire signal chain, target material and monitor input calibration before commissioning.
