Overview
Manuals
Cable Construction
Compatibility Notes
Routing Guidance
Features:
- 9200 and 74712 Seismoprobe Accessory
- 30 ft Cable Length
- Two Shielded 22 AWG Conductors
- Terminal Lugs at Both Ends
- High-Temperature Cable Family
Bently Nevada 84508-30 is an interconnection cable listed for the 9200 and 74712 Seismoprobe Velocity Transducer family. It carries the self-generated moving-coil velocity signal to compatible monitoring or diagnostic equipment.
This 30-foot configuration uses two shielded 22 AWG conductors and terminal lugs at both ends. Confirm the installed cable route, shield termination, input impedance and polarity before commissioning.
The 84508-30 Bently Nevada high-temperature seismoprobe interconnection cable may be supplied and supported by Moore Automated according to the stated OEM lifecycle and confirmed stock condition.
Bently Nevada 84508-30 High-Temperature Seismoprobe Interconnection Cable Manuals(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Cable Construction:
- 30 ft nominal length
- Two shielded conductors
- 22 AWG wire size
- Terminal lugs at both ends
- Listed for Seismoprobe systems
The cable provides the two-wire signal path between compatible Seismoprobe installations and monitoring equipment.
Compatibility Notes:
- 9200 Seismoprobe family
- 74712 high-temperature Seismoprobe family
- Terminal-lug connections
- Monitor input verification
- Shield continuity required
Confirm the exact transducer, monitoring input and terminal arrangement before installing the interconnection cable.
Routing Guidance:
- Plan the full 30 ft route
- Protect lugs and shield from damage
- Separate the cable from interference sources
- Maintain secure terminal connections
- Verify polarity before operation
Route and secure the cable so temperature, abrasion and electrical interference do not degrade the velocity signal.
