Registered Address: 32D Floor Guomao Building, No.388, Hubin South Road, Siming District, Xiamen,Fujian, China
The General Electric IC695CPU310 is a cpu processor module for PACSystems RX3i industrial automation applications. Documented product details include PACSystem RX3i Processor module; processor has 10MB RAM and 10MB; non-volatile user memory, processor; speed of 300 MHz with typical scan; rate of 0.195 ms per 1000 Boolean; instructions. Confirm the complete model code, hardware revision and supplied condition against the installed equipment before replacement.
Verify that the supplied item is marked IC695CPU310 and that its cpu processor module form, connectors and revision agree with the approved PACSystems RX3i receiving record.
For IC695CPU310, state the required condition, quantity, installed position, connected assemblies and document requirements in the written enquiry.
Apply only parameters supported by the exact IC695CPU310 record or a documented family source. Do not infer electrical ratings or interchangeability from appearance.
IC695CPU310 technical scope: Product Line: RX3i PacSystem; NVRAM: 10 Megabytes; Microprocessor: RX3i VME 300Mhz CPU; Clock Speed: 300 MHz; Communication standards: RS232; RS485.
Use these values only for the listed hardware execution and verify the supplied label before installation.
Match IC695CPU310 to the approved PACSystems RX3i receiving position, connector or terminal arrangement and configuration record.
After power restoration, review diagnostics and test the affected cpu processor module path.
Active / Available from OEM
IC695CPU310 is a General Electric cpu processor module associated with the PACSystems RX3i platform. It supports the documented controller execution, communications and configuration functions assigned to the installed processor position. Correct selection depends on the complete model code, connector or terminal arrangement, hardware revision and receiving-system configuration. Before replacement, compare the original product label, installed slot or cabinet reference, connected assemblies and approved project records. After installation, review system diagnostics and function-test every affected channel, control path, protection function or communication link before returning the equipment to service.