Overview
Manuals
Dual-Sided Access
Equipment Scope
Drawing Match
Features:
- Basic cabinet assembly for the Honeywell Series C platform.
- Dual-access arrangement for front and rear equipment access.
- Installed electronics and accessories are defined by the project bill of materials.
Honeywell CC-CBDD01 is identified as a basic dual-access Series C cabinet assembly in manufacturer project equipment listings. Its function is to provide the physical cabinet arrangement for the specified control-system installation; it does not perform analog conversion, discrete input sensing or controller execution by itself. The practical selection questions concern the cabinet assembly, access arrangement, internal mounting provisions and the equipment that is actually included with the offered unit.
A replacement cabinet should be checked against the project general-arrangement drawing and bill of materials before any internal equipment is transferred. Confirm the front and rear access space, cable entries, mounting arrangement, bonding provisions and agreed internal fittings. Honeywell planning literature also uses the designation CU-CBDD01 for a cabinet frame, which must not be treated as proof of the complete CC-CBDD01 supply scope. Exact dimensions, mass and protection rating remain dependent on verified assembly documentation.
The CC-CBDD01 Honeywell Series C Dual-Access Cabinet may still be available for purchase and support from Moore Automated Company beyond End-Of-Life (EOL) by the manufacturer (OEM).
Honeywell CC-CBDD01 cabinet documentation and reference links.
Important Notice: A verified public PDF for the exact CC-CBDD01 cabinet assembly is not currently attached. Request the assembly drawing; a CU-CBDD01 frame document is not presented as an exact substitute.
Provide working access at both sides of the installed cabinet. The required clearance depends on the door arrangement, internal equipment and site maintenance practice. Check the project layout before placing the cabinet near a wall or another enclosure; dual access does not mean the required rear working space can be omitted.
Separate the basic cabinet assembly from the controllers, I/O assemblies, power supplies and ancillary equipment installed inside it. The same cabinet designation can appear within a larger project equipment list. Use the agreed bill of materials to determine which fittings and electronics are supplied, rather than inferring them from a representative photograph.
Verify the complete CC-CBDD01 marking against the cabinet general-arrangement drawing and the offered assembly. Record door orientation, mounting provisions and cable entry locations. Do not copy a frame-only dimension or an unrelated input-module electrical rating into the cabinet specification; those describe different supplied items.
