Overview
Manuals
Enclosure Selection
Mounting & Access
Installation Checks
Features:
- The documented mounting block is Configured with a dedicated structural mounting bracket block or standardized low-profile button housing; confirm the installed mounting interface, available reach and mechanical clearance before replacement.
- The documented total cable length is 1.0-meter (3.3 feet); retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented connector is Terminates in a standard, miniature coaxial ClickLoc connector with an included connector protector; verify the connector interface, electrical length and matching 3300 signal-chain components before commissioning.
330232-01-10-12-00 is a Bently Nevada 3300 XL Proximity Probe for the 3300 system. It measures shaft vibration or position without contact in a matched transducer chain. Key specifications: Total Cable Length: 1.0-meter (3.3 feet); Agency Approval: None Required. Match the full order code and hardware before replacement.
Confirm the complete 330232-01-10-12-00 order code, installed signal chain, mounting arrangement and commissioning record before replacement.
The exact 330232-01-10-12-00 execution must be confirmed by its complete order code, condition, connected 3300 system and included scope before purchase or replacement.
Bently Nevada 330232-01-10-12-00 3300 XL Proximity Probe manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Check the complete 330232-01-10-12-00 housing code against the documented material, probe penetration, thread, fittings and access arrangement. Retained facts: Mounting Block: Configured with a dedicated structural mounting bracket block or standardized low-profile button housing; Total Cable Length: 1.0-meter (3.3 feet); Connector: Terminates in a standard, miniature coaxial ClickLoc connector with an included connector protector.
Confirm the installed probe, standoff, conduit fittings, sealing and machine-case interface together. A matching outside shape alone does not establish interchangeability.
Verify probe travel and gap access, tighten fittings to the approved practice, confirm sealing and route the probe lead without damage before returning the machine to service.
