Overview
Manuals
Ceramic Tip Design
Process-Media Fit
Seal & Gap Checks
Features:
- The documented probe type is 3300 Ceramic Capped Probe without rear fitting; retain this specification when matching the exact 3300 ceramic capped proximity probe and installed Bently Nevada 3300 hardware.
- The documented mounting thread is 3/8-24 UNF; confirm the installed mounting interface, available reach and mechanical clearance before replacement.
- The documented case length is 3.2 in (81.3 mm); retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
146054-32-05-01-05 is a Bently Nevada 3300 Ceramic Capped Proximity Probe for the 3300 system. It measures shaft vibration or position without contact in a matched transducer chain. Key specifications: Mounting thread: 3/8-24 UNF; Case length: 3.2 in (81.3 mm). Match the full order code and hardware before replacement.
146054-32-05-01-05 is a pressure-rated ceramic-capped eddy-current proximity probe with a helium-leak-tested interface, 304 stainless-steel case and ordering-code-defined lead and connection options.
The exact 146054-32-05-01-05 execution must be confirmed by its complete order code, condition, connected 3300 system and included scope before purchase or replacement.
Bently Nevada 146054-32-05-01-05 3300 Ceramic Capped Proximity Probe manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Preserve every option block of 146054-32-05-01-05. Retained facts: Probe type: 3300 Ceramic Capped Probe without rear fitting; Mounting thread: 3/8-24 UNF; Case length: 3.2 in (81.3 mm). Mechanical length, thread, cable/connector and approval suffixes are part of the exact probe identity.
Match probe family, electrical length, extension cable and Proximitor Sensor. Confirm target material, available travel, nearby probe spacing and mounting geometry before exchange.
Set the operating gap from live bias voltage, support the cable above its bend limit and verify runout, vibration or position response against the commissioning baseline.
