Overview
Manuals
Reverse-Mount Code
Rear-Mount Geometry
Gap Setup
Features:
- The documented value for probe case type is 3/8-24 UNF threads; retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented value for total length is 1.0 meter (3.3 feet); retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented value for agency approval is Not required; the complete approval suffix must match the installation area and site requirements.
330195-02-12-10-00 is a Bently Nevada 3300 XL 8 mm (ETR) Reverse Mount Probes for the 3300 system. It connects the probe to a compatible Proximitor Sensor. Key specifications: Probe Case Type: 3/8-24 UNF threads; Total Length: 1.0 meter (3.3 feet). Match the full order code and hardware before replacement.
Confirm the complete 330195-02-12-10-00 order code, installed signal chain, mounting arrangement and commissioning record before replacement.
The exact 330195-02-12-10-00 execution must be confirmed by its complete order code, condition, connected 3300 system and included scope before purchase or replacement.
Bently Nevada 330195-02-12-10-00 3300 XL 8 mm (ETR) Reverse Mount Probes manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Preserve every option block of 330195-02-12-10-00. Retained facts: Probe Case Type: 3/8-24 UNF threads; Total Length: 1.0 meter (3.3 feet); Agency Approval: Not required. Mechanical length, thread, cable/connector and approval suffixes are part of the exact probe identity.
Match probe family, electrical length, extension cable and Proximitor Sensor. Confirm target material, available travel, nearby probe spacing and mounting geometry before exchange.
Set the operating gap from live bias voltage, support the cable above its bend limit and verify runout, vibration or position response against the commissioning baseline.
