Overview
Manuals
50 mm Range Code
Differential Expansion Fit
Target Setup
Features:
- The documented probe case is 01 - 1/2-20 thread; retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented total probe length is 1.0 m; retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented cable option is 00 - High-temperature FluidLoc cable without armor; verify the connector interface, electrical length and matching 3300 signal-chain components before commissioning.
330876-01-10-00-00 is a Bently Nevada 3300 XL 50 mm proximity probe for the 3300 system. It measures shaft vibration or position without contact in a matched transducer chain. Key specifications: Probe case: 01 - 1/2-20 thread; Total probe length: 1.0 m. Match the full order code and hardware before replacement.
The 330876-01-10-00-00 is a 1/2-20 threaded 3300 XL 50 mm probe with a 1.0-meter high-temperature FluidLoc lead, no armor and no approvals. The matched system provides 27.9 mm linear range and 394 mV/mm nominal average scale factor.
The exact 330876-01-10-00-00 execution must be confirmed by its complete order code, condition, connected 3300 system and included scope before purchase or replacement.
Bently Nevada 330876-01-10-00-00 3300 XL 50 mm proximity probe manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Preserve every option block of 330876-01-10-00-00. Retained facts: Probe case: 01 - 1/2-20 thread; Total probe length: 1.0 m; Cable option: 00 - High-temperature FluidLoc cable without armor. Mechanical length, thread, cable/connector and approval suffixes are part of the exact probe identity.
Match probe family, electrical length, extension cable and Proximitor Sensor. Confirm target material, available travel, nearby probe spacing and mounting geometry before exchange.
Set the operating gap from live bias voltage, support the cable above its bend limit and verify runout, vibration or position response against the commissioning baseline.
