Overview
Manuals
Cable Selection
Route Protection
Installation Review
Features:
- The 16710 base number identifies the armored interconnect-cable family listed for the 177230 Seismic Transmitter.
- Suffix -15 specifies a 15 ft ordered length, approximately 4.5 m, within the official 3 to 99 ft one-foot range.
- Replacement requires matching the complete cable identity, armored construction and both installed connection interfaces.
Bently Nevada 16710-15 is the 15 ft armored interconnect-cable execution documented for the 177230 Seismic Transmitter system. The -15 suffix records the ordered length and must be matched to the actual route rather than treated as optional. Verify the full label, both terminations, connected equipment, support and grounding continuity before using this cable as a replacement.
Manufacturer reference: Baker Hughes/Bently Nevada 177230 Seismic Transmitter Datasheet 177232, 16710-AA armored cable ordering table.
Moore Automated supports exact-item verification and spare-part enquiries for 16710-15.
Bently Nevada 16710-15 armored cable documentation and official product resources, Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Choosing the documented cable length
The -15 suffix is an ordering-code value and identifies the 15 ft armored execution.
- Measure the installed route before confirming the replacement length.
- Keep the armored 16710 family designation when the documented installation requires mechanical protection.
- Use a different length suffix only when the approved drawing or installed label supports that change.
Protecting the signal route
The armored construction protects the interconnect while correct routing preserves the measurement path.
- Maintain the documented bend radius and cable support points.
- Keep the run separated from avoidable electrical-noise sources.
- Preserve shield and grounding continuity through both connection ends.
Review before installation
A complete replacement check covers identity, interfaces and the physical 15 ft route.
- Compare 16710-15 with the removed cable label and system documentation.
- Verify the connected 177230 transmitter arrangement and monitor-side termination.
- Inspect the installed signal after routing and securing the cable.
