Overview
Manuals
Standard Performance
MOD Configuration
Replacement Guidance
Features:
- Special 3300 5 mm Proximity Probe
- MOD 142824-100 Configuration
- 1/4-28 UNF Unarmored Platform
- 1.0 m Standard Cable
- Code 05 Multiple Approvals
Bently Nevada 330171-XX-XX-10-02-05 MOD:142824-100 is a special 3300 5 mm eddy-current proximity probe. It provides non-contact shaft vibration and position measurements when installed as part of a matched transducer system.
The XX unthreaded-length and case-length positions are controlled by MOD 142824-100. The visible suffixes specify a 1.0-meter standard lead, ClickLoc connector without protector and multiple approvals; verify every nameplate detail before replacement.
The 330171-XX-XX-10-02-05 MOD:142824-100 Bently Nevada special 3300 5 mm proximity probe may be supplied and supported by Moore Automated according to the stated OEM lifecycle and confirmed stock condition.
Bently Nevada 330171-XX-XX-10-02-05 MOD:142824-100 Special 3300 5 mm Proximity Probe Manuals(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Standard Performance:
- 2.0 mm linear range
- 7.87 V/mm nominal scale factor
- 1.27 mm recommended gap
- 0 to 10 kHz frequency response
- Compact 5.2 mm probe tip
Standard system performance depends on the matched 3300 5 mm probe, extension cable, Proximitor Sensor and target material.
MOD Configuration:
- 330171 unarmored 1/4-28 UNF platform
- XX unthreaded length
- XX overall case length
- 10: 1.0 m total probe length
- 02: standard ClickLoc cable without protector
- 05: multiple approvals
The two XX dimensions and MOD 142824-100 must be verified from the manufacturer-controlled configuration rather than inferred.
Replacement Guidance:
- Match MOD 142824-100 exactly
- Confirm both XX dimensions
- Use the correct 3300 XL extension cable
- Verify code-05 approval drawings
- Set the gap after full system assembly
Treat the complete nameplate identity as the replacement key and commission the probe only after mechanical and electrical compatibility are confirmed.
