Overview
Manuals
Basic Info
Ordering Information
Industrial applications
Features:
- Low Pressure Cable Seal
- 3300XL Transducer Accessories
- Accessories contribute to a reliable transducer system
The 43501 Low Pressure Cable Seal provides a means to pass through a single hole in a machine case or other barrier one to four 95-ohm transducer cables or one to two 25mm DE and 50mm DE transducer cables. A molded silicone rubber grommet provides a seal to prevent leakage of fluids along the outer jacket of the cable(s). The seal mounts in a hole tapped with either ½-NPT or ¾-NPT pipe threads in the machine and has external pipe threads on both ends to mate to the tapped hole and to mating conduit or housings.
The seal is rated to 345 kPa (50 psi) across grommet high pressure to low pressure. The seal is rated only on the cable outer jacket and seal body itself. It does not seal leaks through the cable braid or center conductor due to pinholes or cuts in the cable jacket or through the probe or connector. The primary intended usage is to seal lube oil to exit bearing housings and machine cases. The seal is rated to 1.0 psi absolute, but is limited in practice by the cable, probe, and connector as with pressure.
The 43501-01-04-01 Bently Nevada Low Pressure Cable Seal may still be available for purchase and support from Moore Automated Company beyond End-Of-Life (EOL) by the manufacturer (OEM).
Bently Nevada 43501-01-04-01 Low Pressure Cable Seal Manuals(Datasheets), Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
- Model: 43501-01-04-01
- Warranty: One-year warranty
- Condition: Brand new, original, in stock
- Product Family: 3300XL Transducer Accessories
Low Pressure Cable Seal
43501 – Axx – Bxx-Cxx
A: High Pressure Side Thread Size
0 1: 1/2-14 NPT
0 2: 3/4-14 NPT
B:Cable Grommet and Washer
0 0: Solid grommet (no holes). Holes must be punched in grommet.
0 2: Grommet will accommodate up to two 25mm and 50mm DE
cables. One hole is punched and one is partially pre-drilled.
0 4: Grommet will accommodate up to 4 cables. One hole is punched and three are partially predrilled.
C:Low Pressure Side Thread Size
0 1: 1/2-14 NPT
0 2: 3/4-14 NPT
In industrial applications, this sealing connector consists of a high-strength 303 stainless steel housing and a molded silicone rubber ring. Its core sealing interface can withstand internal and external pressure differences of up to 345 kPa (50 psi), ensuring long-term airtight and liquid-tight seals in lubricating oil bath environments. Because it achieves through-shell sealing solely through radial compression of the cable's outer sheath, it is typically only suitable for unarmored standard cables. This connector is an indispensable physical barrier in Bentley condition monitoring circuits, effectively preventing lubricant leakage and avoiding contamination by external connectors or cable signal attenuation.
