Overview
Manuals
Cable Length Code
Long-Range System
Routing Checks
Features:
- The documented cable length code is 040; retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented cable length is 4.0 m; retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented cable option is 25 - High-temperature FluidLoc with stainless-steel armor; verify the connector interface, electrical length and matching 3300 signal-chain components before commissioning.
330854-040-25-05 is a Bently Nevada 3300 XL 25 mm high-temperature extension cable for the 3300 system. It connects the probe to a compatible Proximitor Sensor. Key specifications: Cable length code: 040; Cable length: 4.0 m. Match the full order code and hardware before replacement.
330854-040-25-05 is a 3300 XL 25 mm extension cable in the 3300 XL 25 mm Proximity Transducer System. Verify the complete ordering code, matched components, installation geometry, environmental limits, and any MOD-controlled details before commissioning.
The exact 330854-040-25-05 execution must be confirmed by its complete order code, condition, connected 3300 system and included scope before purchase or replacement.
Bently Nevada 330854-040-25-05 3300 XL 25 mm high-temperature extension cable manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Review 330854-040-25-05 by complete length and construction code. Retained facts: Cable length code: 040; Cable length: 4.0 m; Cable option: 25 - High-temperature FluidLoc with stainless-steel armor. Do not change the calibrated total system length when replacing an extension or integral lead.
Match every connector, protector, armor or FluidLoc option and the receiving probe/Proximitor Sensor. Route the cable without sharp bends, crushing, connector side-load or contamination.
Inspect continuity and insulation where applicable, seat the connectors, compare channel bias with the recorded value and confirm stable vibration or position response before release.
