Overview
Manuals
NSv Cable Code
NSv System Length
Connector Checks
Features:
- The documented cable length is 6.5 m (21.3 ft); retain this dimension when checking mounting geometry, routing and compatibility with the installed hardware.
- The documented connector and cable option is 04; verify the connector interface, electrical length and matching 3300 signal-chain components before commissioning.
- The documented armor configuration is Stainless steel armor; preserve this construction together with the complete order code and cable-routing requirements.
330930-065-04-BR is a Bently Nevada 3300 NSv extension cable for the 3300 system. It connects the probe to a compatible Proximitor Sensor. Key specifications: Cable Length: 6.5 m (21.3 ft); Connector and Cable Option: 04. Match the full order code and hardware before replacement.
330930-065-04-BR is a 6.5 m 3300 NSv extension cable with stainless steel armor, FEP jacket, connector protector and BR country-specific approval option. Pair it with a 0.5 m NSv probe and a 7 m 330980 Proximitor Sensor.
The exact 330930-065-04-BR execution must be confirmed by its complete order code, condition, connected 3300 system and included scope before purchase or replacement.
Bently Nevada 330930-065-04-BR 3300 NSv extension cable manual (Datasheet), Link
Important Notice: Confirm the complete order code, hardware execution and connected system before replacement. Accessories, cables, calibration data, software and certificates are included only when stated in the written quotation.
Review 330930-065-04-BR by complete length and construction code. Retained facts: Cable Length: 6.5 m (21.3 ft); Connector and Cable Option: 04; Armor: Stainless steel armor. Do not change the calibrated total system length when replacing an extension or integral lead.
Match every connector, protector, armor or FluidLoc option and the receiving probe/Proximitor Sensor. Route the cable without sharp bends, crushing, connector side-load or contamination.
Inspect continuity and insulation where applicable, seat the connectors, compare channel bias with the recorded value and confirm stable vibration or position response before release.
